Skip to content
Serving Livermore and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (650) 203-2763

Heat Pump Installation in Danville, CA

Serving Danville and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (650) 203-2763

The short answer

A properly sized heat pump can handle both heating and cooling for a Danville home, replacing a separate furnace and air conditioner. Bay Area Air District rules don't force you to replace working equipment, but gas furnaces made from 2029 must meet a zero-NOx standard, so many homeowners are planning the switch before their furnace fails.

For many Danville homeowners, the real question isn't whether a heat pump can heat and cool their house. It's whether now is the right time to switch. TotalFlow HVAC Repair Service installs ducted and ductless heat pumps in Danville (94526) and throughout the San Ramon Valley, driving up from our Livermore base about 13 miles southeast. We start by looking at how your home heats and cools today, including the existing furnace and air conditioner, the ductwork, and the electrical panel. Then we help you decide whether replacing now or planning for later makes more sense for your house and budget.

Why Danville Homeowners Are Looking at Heat Pumps Now

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. The rule doesn't require you to tear out a furnace that still works. It applies only when existing equipment fails or is replaced.

That gives Danville homeowners room to plan. If your furnace or air conditioner is getting older, choosing a heat pump on your own schedule is usually easier than making a rushed decision on a cold night when the furnace stops working. Planning ahead lets you check your electrical capacity, compare system types, and look into current incentives without time pressure.

What We Check Before Recommending a System

A heat pump has to be matched to the house, not just to the size of the old furnace. Older equipment is often oversized, and copying it can lead to short cycling, uneven rooms, and wasted energy. Before we recommend anything, we look at:

  • Heating and cooling load, calculated room by room from insulation, windows, orientation, and square footage
  • Duct condition, sizing, and leakage, since a heat pump moves air differently than many older furnaces
  • Electrical panel capacity and whether a new circuit or panel work is needed
  • Outdoor unit placement, including noise toward neighbors, clearances, and any HOA requirements
  • The age and condition of your current air conditioner and furnace
  • Thermostat compatibility and how you want to control the system

Ducted, Ductless, or Dual-Fuel: Choosing for Your Home

Most Danville homes with existing ductwork are good candidates for a ducted heat pump. It replaces the outdoor air conditioner and pairs with an indoor air handler, so one system covers both summer cooling and winter heating. If the ducts are in good shape, this is usually the cleanest swap.

Ductless mini-splits work well for additions, converted garages, bonus rooms, and older sections of a house that never had ducts. They also help with rooms that always run hotter or colder than the rest of the house.

Some homeowners choose a dual-fuel setup, where a heat pump handles most of the load and an existing gas furnace serves as backup. This can make sense if your furnace is still in good condition but your air conditioner is due for replacement. We'll walk through the tradeoffs so you can compare these options for your specific house.

Incentives and Tax Credits: What's True Right Now

The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date, so it shouldn't factor into a project you're planning today.

Local programs are still worth checking. Danville homeowners can look at BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before including it in a quote.

If you're also thinking about a heat pump water heater, check the current rule first. The zero-NOx date for small water heaters under Rule 9-6 was set for 2027, and the Air District Board is considering amendments in November 2026 that could delay it.

What to Expect on Installation Day

Once you've chosen a system, we schedule the work and explain ahead of time what will happen and how long the heating and cooling will be off. A typical ducted replacement includes removing the old equipment, setting the outdoor unit on a level pad, installing the indoor air handler or coil, running refrigerant lines and wiring, and making any duct adjustments we identified during the assessment.

Before we leave, we start the system, check airflow and refrigerant charge, confirm that heating and cooling modes both work, and show you how to use the thermostat. We'll also go over basic upkeep, such as filter changes and keeping the outdoor unit clear of leaves and debris.

More services in Danville

Related

What to expect

How a visit goes

  1. Find the cause first

    We test and inspect before recommending parts or equipment, so the fix matches the actual problem instead of a guess.

  2. Clear options, no pressure

    When a system could be repaired or replaced, we lay out both paths and the tradeoffs, then let you decide what fits your home.

  3. Current information on rules and incentives

    Air District rules and rebate programs change. We confirm what applies today before we talk about it, so you can plan with accurate information.

FAQ

Common questions

Do I have to replace my gas furnace because of the Bay Area Air District rules?

No. The Air District appliance rules don't require replacing working equipment. They apply only when an existing furnace or water heater fails or is replaced.

What happens if my furnace fails after 2029?

Gas furnaces manufactured from 2029 must meet a zero-NOx emission standard under Rule 9-4. In practice, that makes a heat pump the likely replacement, which is why many homeowners plan ahead.

Can I still get the federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date.

Are there local incentives for heat pumps in Danville?

Possibly. Check BayREN and your local clean energy provider. Offers change by funding cycle, so we confirm what's currently available before quoting it.

Will my electrical panel handle a heat pump?

Many panels can, but not all. We check panel capacity and available circuits during the assessment and tell you upfront if any electrical work is needed.

Do you install heat pumps outside Danville?

Yes. Along with Danville, we serve San Ramon, Dublin, Clayton, Pleasanton, Union City, and our home base of Livermore.

Need Heating or Cooling Help in Livermore?

Tell us what your system is doing, or not doing, and we'll schedule a visit to find the cause and walk you through your options.

(650) 203-2763
Call (650) 203-2763 Request Service