Skip to content
Serving Livermore and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (650) 203-2763

HVAC Repair in Contra Costa County, CA

The short answer

TotalFlow HVAC Repair Service travels from Livermore to repair furnaces, air conditioners and heat pumps across Contra Costa County, from San Ramon and Danville to Brentwood and Discovery Bay. Bay Area Air District rules don't require you to replace working equipment, but they do shape your options when a furnace or water heater is replaced.

TotalFlow HVAC Repair Service travels from our base in Livermore into Contra Costa County to fix furnaces, heat pumps and central air conditioners. The San Ramon Valley is about 18 miles from us. We serve communities from Camino Tassajara and Blackhawk through Danville, Alamo and Diablo, out to Clayton, and east to Brentwood, Byron and Discovery Bay. This page covers what we repair, how a visit works, and what current Bay Area rules mean if a repair turns into a replacement.

Contra Costa Communities We Serve

Most of our Contra Costa calls come from the San Ramon Valley and the eastern side of the county. When you book, tell us your community and nearest cross streets. That helps us plan the drive and give you a realistic arrival window.

  • San Ramon, Danville, Alamo, Diablo and Blackhawk
  • Camino Tassajara and Norris Canyon
  • Clayton and San Miguel
  • Brentwood, Byron and Discovery Bay

Common HVAC Repairs We Handle

Hot inland summers mean long run times for air conditioners, and cool winter nights keep furnaces cycling. The problems we see most often follow those patterns.

  • Air conditioners that run but blow warm air, often from a failed capacitor, a dirty condenser coil or a refrigerant leak
  • Furnaces that won't light or shut off early, commonly traced to a dirty flame sensor, a worn igniter or a clogged filter
  • Heat pumps stuck in one mode or icing up outside
  • Thermostats that stop communicating with the equipment
  • Weak airflow from dirty filters, failing blower motors or leaky ductwork
  • Clogged condensate drains that leave water around the indoor unit

What to Expect on a Repair Visit

A technician checks the whole system, not just the part that failed. We test electrical components, inspect burners or coils, measure airflow and look at the condensate drain. Before any work starts, we explain what we found and what the repair involves, so you can decide how to proceed.

Before you call, confirm the thermostat has power and is set correctly, the breaker hasn't tripped, and the filter isn't clogged. Those three checks solve some no-heat and no-cool problems on their own.

Repair or Replace: What Bay Area Rules Mean

The Bay Area Air District's appliance rules do not require you to replace equipment that still works. They apply only when an existing furnace or water heater fails or is replaced.

For furnaces, natural gas models manufactured from 2029 onward must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date, so it's worth weighing if your furnace is aging. For small water heaters, the zero-NOx date was set for 2027, and the Air District Board is considering amendments in November 2026 that could delay it. Check the current rule before planning a water heater replacement.

Heat Pump Incentives

The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations. You can still check BayREN and your local clean energy provider for current heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before quoting it.

Communities we serve here

What to expect

How a visit goes

  1. Find the cause first

    We test and inspect before recommending parts or equipment, so the fix matches the actual problem instead of a guess.

  2. Clear options, no pressure

    When a system could be repaired or replaced, we lay out both paths and the tradeoffs, then let you decide what fits your home.

  3. Current information on rules and incentives

    Air District rules and rebate programs change. We confirm what applies today before we talk about it, so you can plan with accurate information.

FAQ

Common questions

Do you serve all of Contra Costa County?

We focus on the San Ramon Valley, Clayton, San Miguel and East County communities including Brentwood, Byron and Discovery Bay. If your town isn't listed, ask when you call and we'll tell you whether we can reach you.

Do I have to replace my gas furnace because of the new Air District rules?

No. The rules don't require replacing working equipment. They apply only when a furnace fails or is replaced, and the zero-NOx standard covers gas furnaces manufactured from 2029.

Should I repair my old furnace or switch to a heat pump?

It depends on the furnace's condition, the cost of the repair and your plans for the house. We'll explain what's wrong and lay out both options so you can compare them.

Can I still get the federal tax credit for a heat pump?

No. The 25C credit covered qualifying heat pumps placed in service before December 31, 2025. Check BayREN and your local clean energy provider for current incentives.

What should I check before calling for repair?

Make sure the thermostat has power and the right settings, the breaker hasn't tripped, and the air filter is clean. If the system still won't run, call us.

Is the water heater zero-NOx date still 2027?

It was set for 2027, but the Air District Board is considering amendments in November 2026 that could delay it. Check the current rule before planning a replacement.

Need Heating or Cooling Help in Livermore?

Tell us what your system is doing, or not doing, and we'll schedule a visit to find the cause and walk you through your options.

(650) 203-2763
Call (650) 203-2763 Request Service