The short answer
Yes, a heat pump can heat and cool a Brentwood home with one system. The key is sizing it to your house and checking your ducts and electrical panel before installation. You don't have to replace a working furnace now, but Bay Area rules will push gas furnace replacements toward heat pumps after 2029.
Brentwood summers get hot, and many homes here run an air conditioner hard from late spring into fall, then switch to a gas furnace for the cooler, damp months. A heat pump handles both jobs with one outdoor unit, using electricity to move heat out of the house in summer and into it in winter. TotalFlow HVAC Repair Service installs heat pumps for Brentwood homeowners from our base in Livermore, about 18 miles south. We focus on fitting the system to your house, your ductwork and your electrical service so it keeps up on the hottest afternoons and doesn't short-cycle on mild days.
Why Brentwood Homeowners Are Looking at Heat Pumps
In East Contra Costa County, cooling is often the bigger load. A heat pump is an air conditioner that can also run in reverse, so you get the same summer cooling plus heating from the same equipment. For homes that already have central air, that can mean replacing an aging AC and furnace with one system instead of two.
Many homeowners also start thinking about heat pumps because of upcoming Bay Area Air District rules. Planning ahead gives you time to compare options instead of making a rushed decision when an old furnace quits in January.
Sizing a Heat Pump for Your Home
An oversized system cools the air quickly but turns on and off often. That wastes energy, wears parts and leaves the house feeling clammy. An undersized one runs nonstop on hot afternoons and can't keep up. We size the system from your actual home, not just its square footage.
Before we recommend equipment, we look at:
- Insulation, window area and which way the house faces, since west-facing rooms take on a lot of afternoon heat
- Your existing ductwork, including leaks, crushed runs and whether duct sizes match the airflow a heat pump needs
- Your electrical panel and whether it has capacity and space for the new circuit
- Where the outdoor unit can sit with good airflow and reasonable distance from bedrooms and neighbors
- Whether a ducted system, a ductless mini-split or a mix makes sense for rooms that are always too hot or too cold
What Installation Looks Like
Most ducted replacements follow the same steps. We remove the old equipment, set the new outdoor unit on a level pad, install the indoor air handler or a heat pump coil matched to your furnace, run the refrigerant lines and wire the new thermostat. Then we charge the system, check airflow at the registers and test it in both heating and cooling mode before we leave.
We'll walk you through the thermostat settings that matter. Heat pumps work best with steady temperatures rather than big setbacks, and we'll show you how to avoid running backup electric heat when you don't need it.
If your ducts need sealing or resizing, or your panel needs work, we tell you up front so it can be planned into the job instead of discovered halfway through.
Bay Area Rules and Incentives to Know
Brentwood is within the Bay Area Air District. Under its furnace rule, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. These rules do not require you to replace working equipment. They apply only when an existing furnace or water heater fails or is replaced.
If you're also thinking about a heat pump water heater, note that the zero-NOx date for small water heaters was set for 2027, and the Air District Board is considering amendments this November that could delay it. Check the current rule before you plan that replacement.
The federal Energy Efficient Home Improvement Credit covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations after that date. You can still check BayREN and your local clean energy provider for heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before including it in a quote.
Serving Brentwood and Nearby Communities
We schedule heat pump consultations and installations throughout Brentwood. We also work in Clayton, Danville, San Ramon, Dublin and Tracy. If you're comparing a straight AC replacement with a heat pump, we can price both so you can see the difference for your own house.
More services in Brentwood
- AC Repair in BrentwoodLocal service & repairs
- Heating Repair in BrentwoodLocal service & repairs
- AC Installation in BrentwoodLocal service & repairs
- Furnace Repair in BrentwoodLocal service & repairs
